BMR4582132/014 Module DC-DC 1-OUT 12V 50A 600W Through Hole

15-Pin Quarter-Brick Tray

General information

Power DC/DC converters and DC/DC regulators aredesigned in accordance with the safety standards

IEC 62368-1, EN 62368-1 and UL 62368-1 Audio/video,information and communication technology

equipment -Part 1: Safety requirements

IEC/EN/UL 62368-1 contains requirements to prevent injuryor damage due to the following hazards:

• Electrical shock

• Electrically-caused fire

• Injury caused by hazardous substances

• Mechanically-caused injury

• Skin burn

• Radiation-caused injury

On-board DC/DC converters, Power interface modules andDC/DC regulators are defined as component

powersupplies. As components they cannot fully comply with theprovisions of any safety requirements

without “conditions ofacceptability”. Clearance between conductors and betweenconductive parts of the

component power supply andconductors on the board in the final product must meet theapplicable safety

requirements. Certain conditions ofacceptability apply for component power supplies withlimited stand-off

(see Mechanical Information for furtherinformation). It is the responsibility of the installer to ensurethat the

final product housing these components complieswith the requirements of all applicable safety standards

andregulations for the final product.

Component power supplies for general use shall complywith the requirements in IEC/EN/UL 62368-1.

Productrelated standards, e.g. IEEE 802.3af Power over Ethernet,and ETS-300132-2 Power interface at

the input to telecomequipment, operated by direct current (dc) are based onIEC/EN/UL 60950-1 with r

egards to safety

Flex Power DC/DC converters, Power interface modulesand DC/DC regulators are UL 62368-1 recognized

andcertified in accordance with EN 62368-1. The flammabilityrating for all construction parts of the products

meetrequirements for V-0 class material according toIEC 60695-11-10, Fire hazard testing, test flames – 50

Whorizontal and vertical flame test methods.

TP1 = -30 to +95ºC, VI = 36 to 75 V, sense pins connected to output pins unless otherwise specified under

Conditions.Typical values given at: TP1 = +25°C, VI= 53 VI max IO, unless otherwise specified under

Conditions.Additional Cin = 220 µF, Cout = 100 µF. See Operating Information section for selection of

capacitor types.

Features

• Industry standard Quarter-Brick with digital PMBusinterface

58.4 x 36.8 x 13.2 mm (2.30 x 1.455 x 0.519 in)

• High efficiency, typ. 96.4% at half load, 12 Vout

• 2250 Vdc input to output functional isolation

• Baseplate option available

• Meets safety requirements according to IEC/EN/UL62368-1

• PMBus Revision 1.3 compliant

• 8.8 million hours MTBF

• ISO 9001/14001 certified supplier

Power Management

• Configurable soft start/stop

• Precision delay and ramp-up

• Voltage margining

• Voltage/current/temperature monitoring

• Adjustable outp